Application Process

Clean the application side of your magnet and then dry, to remove any dust particles produced during the manufacture. Clean and dry the outside area of your vehicle where you wish to apply the magnet.

Apply the top edge of the magnet to any metal exterior surface on the side or rear of your vehicle where you wish it to be displayed, and roll the magnet down until it is fully attached. Never try to reposition the magnet by sliding it along any painted surface of your vehicle, always remove the magnet by peeling it off from one corner and then repositioning it. When washing your vehicle (either by car wash or by hand) it is always advisable to remove your magnet, clean it and then reapply to the clean dry surface.

Do not:
Apply your automobile magnet to the bonnet or engine compartment due to the temperature extremes and direct sunlight exposure experienced. Do not apply to a newly painted surface that has not had sufficient time to cure properly. Trophy Mag LLC will not be held liable for any damages caused by misuse or failure to follow the instructions listed above.